2010 Dodge Pickup
Mileage
154,400
Service Date
9/15/2025
Services Performed
- BALL JOINT – Remove & Replace – R2500,4WD w/o Independent Front Suspension,One Side,Both,Upper and Lower – [Includes: R&I Steering Knuckle.] – [DOES NOT include alignment.]
- Tire Rotation
- TIRE REPAIR
- ALIGNMENT
- Changed Motor Oil & Replaced Filter, Added 8 QTS Synthetic Motor Oil, Lube Chassis, Check all Fluid Levels
- PINION SHAFT SEAL – Remove & Replace – R2500,R3500 – [Includes: R&I Drive Axle.]
- PROPELLER SHAFT – Remove & Install or Remove & Replace – Two Piece Driveline,To Rear Axle,Front,Shaft
- (Combination) – UNIVERSAL JOINT – Remove & Replace Each
- install banks air intake
- bumper bracket
- steering support
- DISC ROTOR – Remove & Replace – R1500,R2500 Front,Both Sides – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
- (Combination) – BRAKE HOSE – Replace Each Additional
- (Combination) – CALIPER – Replace One
- TIE ROD &/OR END – Remove & Replace – R2500,Rack & Pinion Type Gears Outer,One Side – [Includes: Adjust toe-in only. NOTE: Deduct .4 if alignment is also performed. NOTE: Manufacturer recommends removal of Rack and Pinion Steering Gear when replacing Inne
RANDY O. gave our service a 5 star review on 9/26/2025
